- To remove, slide access door release lever sideways.
- Lift access door open.
- Flip up locking clip on end of beater bar.
- Grasp clip and pull firmly upward in diagonal direction to remove beater bar
- Use scissors or sharp knife to cut through tangled hair and fibers. Clear tangles.
- To replace, insert fixed end of beater bar at downward angle, ensuring proper alignment of drive sprocket tabs.
- Press other side of beater bar down until fully seated into opening
- Flip locking clip down and press to "snap" secure
- Close access door and press to "click" secure
Models: STEVA+ STP010 / VAC+ VAP010
Comments
0 comments
Article is closed for comments.